How to connect the connectivity module to the monitor of my video doorphone?

1. Place the indoor monitor on a support (a table): in the direction shown below (screen down):

2. Without plugging it in, position the connectivity module on the back of the monitor in the orientation below (Somfy logos are in the same direction):

3. Connect the Connectivity module connection cables to the back of the monitor:

• The blue power supply connector with red and black wires on the DC 24V terminal block .
• The blue connector of the outdoor panel with yellow and green wires on the 2nd monitor terminal block .
• Connect anything to the CS/Call station terminal block.
• Insert the cables into all the cable grommets.

4. Position the Connectivity module on the back of the monitor, according to the marks shown below (A).

5. While holding it down, slide the connectivity module upwards until it stops (B).

6. Once fixed, make sure that no cables are sticking out

7. Strip the power supply and Outdoor panel cables identified previously to a length of 10 mm.

8. On the back of the Connectivity module, connect the 2 power wires onto the DC 24V terminal block (7-1), respecting the polarity.

9. Connect the 2 wires of the Outdoor panel onto the CS/Call station terminal block (2) as far as they will go. Polarity doesn't matter. Check that the cables are properly inserted into the terminal blocks by pulling them lightly, then pass them through the notch (3). If the cables (power supply/door station) do not come out of the wall, do not pass them through the mounting wall and use the cable channel (4).

10. Secure the assembly to the mounting bracket by sliding it down to the stop.